Toyota CH-R Service Manual: Dtc Check / Clear

DTC CHECK / CLEAR

CHECK DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Main Body / Trouble Codes.

Body Electrical > Main Body > Trouble Codes

(e) Check for DTCs.

CLEAR DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Main Body / Trouble Codes.

Body Electrical > Main Body > Clear DTCs

(e) Clear the DTCs.

    Diagnosis System
    DIAGNOSIS SYSTEM DESCRIPTION (a) Automatic high beam system data and Diagnostic Trouble Codes (DTCs) can be read from the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be ...

    Data List / Active Test
    DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when decidi ...

    Other materials:

    Toyota CH-R Service Manual > Srs Seat Cushion Airbag Assembly: Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front seat cushion airbag assembly RH removal/installation are shown below. Necessary Procedure ...

    Toyota CH-R Service Manual > Black Out Tape(for Rear Door): Installation
    INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. REPAIR INSTRUCTION Click here 2. INSTALL REAR DOOR OUTSIDE STRIPE (a) Refer to the illustration to position a new rear ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0107