DESCRIPTION
The headlight ECU sub-assembly LH stores this DTC if initialization has not been performed after the ECU was replaced.
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
Note |
|---|---|---|---|---|
|
B2450 |
Initialization has not been Performed |
Initialization of the headlight ECU sub-assembly LH has not been performed |
Headlight ECU sub-assembly LH |
- |
CAUTION / NOTICE / HINT
NOTICE:
Click here
Click here
PROCEDURE
|
1. |
INITIALIZATION HEADLIGHT ECU SUB-ASSEMBLY LH |
(a) Perform initialization of the headlight ECU sub-assembly LH.
Click here
|
|
2. |
CLEAR DTC |
(a) Clear the DTCs.
Click here
|
|
3. |
CHECK FOR DTC |
(a) Turn the ignition switch to ON.
(b) Check for DTCs.
Click here
OK:
DTC B2450 is not output.
HINT:
If the headlight ECU sub-assembly LH stores DTC B2450 even though the ECU has been initialized, there may be a malfunction in the headlight ECU sub-assembly LH.
| OK | |
END (INITIALIZATION WAS NOT COMPLETED) |
| NG | |
REPLACE HEADLIGHT ECU SUB-ASSEMBLY LH |
Vehicle Specifications have not been Stored (B2451)
Headlight Beam Level Control Motor LH Malfunction (B2417,B2418)Toyota CH-R Service Manual > Power Mirror Control System: Parts Location
PARTS LOCATION
ILLUSTRATION
*A
w/ Retract Mirror
-
-
*1
OUTER MIRROR SWITCH ASSEMBLY
*2
OUTER REAR VIEW MIRROR ASSEMBLY LH
*3
OUTER REAR VIEW MIRROR ASSEMBLY RH
*4 ...
Toyota CH-R Service Manual > Brake Control / Dynamic Control Systems: Steering Angle Sensor
Components
COMPONENTS
ILLUSTRATION
*1
SPIRAL CABLE SUB-ASSEMBLY
*2
STEERING SENSOR
Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration)
that must be performed af ...