Toyota CH-R Service Manual: Vehicle Specifications have not been Stored (B2451)

Toyota CH-R Service Manual / Lighting (ext) / Automatic Headlight Beam Level Control System / Vehicle Specifications have not been Stored (B2451)

DESCRIPTION

The headlight ECU sub-assembly LH stores this DTC if the vehicle specifications have not been stored in the ECU.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

Note

B2451

Vehicle Specifications have not been Stored

Vehicle specifications have not been stored

Headlight ECU sub-assembly LH

-

CAUTION / NOTICE / HINT

NOTICE:

If the headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the headlight ECU sub-assembly LH.

Click here

PROCEDURE

1.

SYNCHRONIZE VEHICLE INFORMATION

(a) Synchronize the vehicle information.

Click here

Body Electrical > HL AutoLeveling > Utility

Tester Display

ECU Information Sync
NEXT

2.

CLEAR DTC

(a) Clear the DTCs.

Click here

Body Electrical > HL AutoLeveling > Clear DTCs
NEXT

3.

CHECK FOR DTC

(a) Turn the ignition switch to ON.

(b) Check for DTCs.

Click here

Body Electrical > HL AutoLeveling > Trouble Codes

OK:

DTC B2451 is not output.

OK

END (VEHICLE SPECIFICATIONS WERE NOT STORED)
NG

REPLACE HEADLIGHT ECU SUB-ASSEMBLY LH

    Left Headlight ECU Variation Error (B2456)
    DESCRIPTION This DTC is stored when a headlight ECU sub-assembly LH which is not compatible with the vehicle has been installed. DTC No. Detection Item DTC Detecti ...

    Initialization has not been Performed (B2450)
    DESCRIPTION The headlight ECU sub-assembly LH stores this DTC if initialization has not been performed after the ECU was replaced. DTC No. Detection Item DTC Detec ...

    Other materials:

    Toyota CH-R Service Manual > Black Out Tape(for Rear Door): Installation
    INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. REPAIR INSTRUCTION Click here 2. INSTALL REAR DOOR OUTSIDE STRIPE (a) Refer to the illustration to position a new rear ...

    Toyota CH-R Service Manual > Hazard Warning Switch: Removal
    REMOVAL PROCEDURE 1. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY Click here 2. REMOVE INSTRUMENT CLUSTER FINISH LOWER CENTER PANEL SUB-ASSEMBLY Click here 3. REMOVE INSTRUMENT PANEL CENTER REGISTER ASSEMBLY Click here 4. REMOVE HAZARD WARNING SIGNAL SWITCH A ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0069