DESCRIPTION
This DTC is stored when a headlight ECU sub-assembly LH which is not compatible with the vehicle has been installed.
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
Note |
|---|---|---|---|---|
|
B2456 |
Left Headlight ECU Variation Error |
Incompatible headlight ECU sub-assembly LH is installed |
|
- |
CAUTION / NOTICE / HINT
NOTICE:
If the headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the headlight ECU sub-assembly LH.
Click here
PROCEDURE
|
1. |
CLEAR DTC |
(a) Clear the DTCs.
Click here
|
|
2. |
CHECK FOR DTC |
(a) Turn the ignition switch to ON.
(b) Check for DTCs.
Click here
OK:
DTC B2456 is not output.
| OK | |
USE SIMULATION METHOD TO CHECK
|
|
|
3. |
CHECK ECM |
(a) Check if the part number of the ECM installed to the vehicle is correct.
OK:
Part number is correct.
| OK | |
REPLACE HEADLIGHT ECU SUB-ASSEMBLY LH |
| NG | |
REPLACE ECM |
Height Control Sensor Data Out of Range When Initializing (B2452)
Vehicle Specifications have not been Stored (B2451)Toyota CH-R Service Manual > Wireless Door Lock Control System(w/o Smart Key System): Diagnosis System
DIAGNOSIS SYSTEM
CHECK DLC3
(a) Check the DLC3.
Click here
INSPECT BATTERY VOLTAGE
(a) Measure the vehicle battery voltage.
Standard Voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery.
SELF-DIAGNOSTIC MODE (USING TECHSTREAM)
(a) Connect the Techstream to ...
Toyota CH-R Service Manual > Hood Lock Control Cable Assembly: Components
COMPONENTS
ILLUSTRATION
*1
FRONT FENDER LINER LH
*2
NO. 1 RADIATOR GRILLE RETAINER
*3
NO. 1 RADIATOR TO SUPPORT SEAL
-
-
ILLUSTRATION
*A
w/ Engine Hood Courtesy Switch ...