DESCRIPTION
The headlight ECU sub-assembly LH stores this DTC if the sensor value received from the rear height control sensor sub-assembly LH is out of range when performing initialization of the headlight ECU sub-assembly LH; for example, the vehicle is not level or being jack up.
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
Note |
|---|---|---|---|---|
|
B2452 |
Height Control Sensor Data Out of Range When Initializing |
Rear height control sensor sub-assembly LH value is out of range when initializing |
|
- |
CAUTION / NOTICE / HINT
NOTICE:
If any of the following are performed, it is necessary to initialize the headlight ECU sub-assembly LH.
Click here
PROCEDURE
|
1. |
CLEAR DTC |
(a) Clear the DTCs.
Click here
|
|
2. |
CHECK FOR DTC |
(a) Turn the ignition switch to ON.
(b) Check for DTCs.
Click here
OK:
DTC B2452 is not output.
| OK | |
USE SIMULATION METHOD TO CHECK
|
|
|
3. |
CHECK AND REPLACE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH |
(a) Check the installation condition of the rear height control sensor sub-assembly LH.
OK:
Rear height control sensor sub-assembly LH is installed correctly.
| OK | |
REPLACE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH |
| NG | |
INSTALL PARTS CORRECTLY |
Diagnostic Trouble Code Chart
Left Headlight ECU Variation Error (B2456)Toyota CH-R Service Manual > Charging System: Dtc Check / Clear
DTC CHECK / CLEAR
CHECK DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
(e) Check for DTCs, and then write them down.
Powertrain > Engine and ECT > Tro ...
Toyota CH-R Service Manual > Vehicle Stability Control System: Steering Angle Sensor Internal Circuit (C1433)
DESCRIPTION
This DTC is stored when the skid control ECU (brake actuator assembly) receives
an internal malfunction signal from the steering angle sensor.
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
C1433
Ste ...