DESCRIPTION
The headlight unit (headlight leveling motor) receives a signal from the headlight control ECU sub-assembly to operate. The headlight control ECU sub-assembly receives a signal indicating the operating conditions of the headlight unit (headlight leveling motor).
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
Note |
|---|---|---|---|---|
|
B2417 |
Headlight Beam Level Control Motor LH Malfunction |
Malfunction in headlight leveling motor LH |
|
- |
|
B2418 |
Headlight Beam Level Control Motor RH Malfunction |
Malfunction in headlight leveling motor RH |
|
- |
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
After the headlight ECU sub-assembly LH is replaced, vehicle information registration and initialization are necessary.
Click here
PROCEDURE
|
1. |
CLEAR DTC |
(a) Clear the DTCs.
Click here
|
|
2. |
CHECK FOR DTC |
(a) Turn the ignition switch to ON.
(b) Turn on the headlights using the headlight dimmer switch.
(c) Check for DTCs.
Click here
|
Result |
Proceed to |
|---|---|
|
DTC B2417 and B2418 output does not occur |
A |
|
DTC B2417 output occurs |
B |
|
DTC B2418 output occurs |
C |
| A | |
USE SIMULATION METHOD TO CHECK |
| C | |
GO TO STEP 5 |
|
|
3. |
PERFORM ACTIVE TEST USING TECHSTREAM (DRIVE THE LEVELING MOTOR) |
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / HL AutoLeveling / Active Test.
(e) Read the Data List according to the display on the Techstream.
(f) Using the Techstream, perform the Active Test.
Click here
|
Tester Display |
Measurement Item |
Control Range |
Diagnostic Note |
|---|---|---|---|
|
Drive The Leveling Motor |
Headlight leveling motor upward or downward operation |
Stop/Down/Up |
Perform the Active Test with the engine started and vehicle stopped |
|
Tester Display |
|---|
|
Drive The Leveling Motor |
|
Result |
Proceed to |
|---|---|
|
The Active Test is performed normally |
A |
|
The Active Test is not performed normally |
B |
| A | |
REPLACE HEADLIGHT ECU SUB-ASSEMBLY LH |
|
|
4. |
CHECK HEADLIGHT UNIT ASSEMBLY LH (HEADLIGHT LEVELING MOTOR) |
(a) Temporarily replace the headlight unit assembly LH (headlight leveling motor) with a new or normally functioning one.
(b) Using the Techstream, perform the Active Test.
Click here
|
Tester Display |
Measurement Item |
Control Range |
Diagnostic Note |
|---|---|---|---|
|
Drive The Leveling Motor |
Headlight leveling motor upward or downward operation |
Stop/Down/Up |
Perform the Active Test with the engine started and vehicle stopped |
|
Tester Display |
|---|
|
Drive The Leveling Motor |
|
Result |
Proceed to |
|---|---|
|
The Active Test is performed normally |
A |
|
The Active Test is not performed normally |
B |
| A | |
END (HEADLIGHT UNIT ASSEMBLY LH [HEADLIGHT LEVELING MOTOR] WAS DEFECTIVE) |
| B | |
REPLACE HEADLIGHT ECU SUB-ASSEMBLY LH |
|
5. |
PERFORM ACTIVE TEST USING TECHSTREAM (DRIVE THE LEVELING MOTOR) |
(a) Using the Techstream, perform the Active Test.
Click here
|
Tester Display |
Measurement Item |
Control Range |
Diagnostic Note |
|---|---|---|---|
|
Drive The Leveling Motor |
Headlight leveling motor upward or downward operation |
Stop/Down/Up |
Perform the Active Test with the engine started and vehicle stopped |
|
Tester Display |
|---|
|
Drive The Leveling Motor |
|
Result |
Proceed to |
|---|---|
|
The Active Test is performed normally |
A |
|
The Active Test is not performed normally |
B |
| A | |
REPLACE HEADLIGHT ECU SUB-ASSEMBLY LH |
|
|
6. |
CHECK HEADLIGHT UNIT ASSEMBLY RH (HEADLIGHT LEVELING MOTOR) |
(a) Temporarily replace the headlight unit assembly RH (headlight leveling motor) with a new or normally functioning one.
(b) Using the Techstream, perform the Active Test.
Click here
|
Tester Display |
Measurement Item |
Control Range |
Diagnostic Note |
|---|---|---|---|
|
Drive The Leveling Motor |
Headlight leveling motor upward or downward operation |
Stop/Down/Up |
Perform the Active Test with the engine started and vehicle stopped |
|
Tester Display |
|---|
|
Drive The Leveling Motor |
|
Result |
Proceed to |
|---|---|
|
The Active Test is performed normally |
A |
|
The Active Test is not performed normally |
B |
| A | |
END (HEADLIGHT UNIT ASSEMBLY RH [LEVELING MOTOR] WAS DEFECTIVE) |
| B | |
REPLACE HEADLIGHT ECU SUB-ASSEMBLY LH |
Initialization has not been Performed (B2450)
Vehicle Speed Sensor Malfunction (B2415)Toyota CH-R Service Manual > Compressor(for Denso Made): Installation
INSTALLATION
PROCEDURE
1. ADJUST COMPRESSOR OIL
(a) When replacing the compressor with pulley assembly with a new one,
gradually discharge the refrigerant gas from the service valve. Then drain
the following amount of oil from the new compressor with pulley assembly
before ...
Toyota CH-R Service Manual > Automatic Headlight Beam Level Control System: Terminals Of Ecu
TERMINALS OF ECU
CHECK INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY AND MAIN BODY ECU (MULTIPLEX NETWORK
BODY ECU)
Click here
CHECK HEADLIGHT ECU SUB-ASSEMBLY LH
Click here
CHECK HEADLIGHT ECU SUB-ASSEMBLY RH
Click here
...