INSTALLATION
PROCEDURE
1. INSTALL REAR SPOILER ASSEMBLY
(a) Engage the clips to install the rear spoiler assembly as shown in the illustration.
|
Install in this Direction |
(b) Install the 8 nuts.
Torque:
6.0 N·m {61 kgf·cm, 53 in·lbf}
(c) Connect the connector.
2. INSTALL NO. 2 BACK DOOR PANEL PROTECTOR
Click here
3. INSTALL NO. 1 BACK DOOR PANEL PROTECTOR
HINT:
Use the same procedure as for the LH side.
4. INSTALL BACK DOOR TRIM UPPER PANEL ASSEMBLY
Click here
Reassembly
Rear Wheel House PlateToyota CH-R Service Manual > Vehicle Stability Control System: Brake Actuator Operation Sound is Loud during Initial Check
CAUTION / NOTICE / HINT
NOTICE:
When replacing the skid control ECU (brake actuator assembly), perform system
variant learning.
Click here
PROCEDURE
1.
PERFORM ROAD TEST
(a) After turning the ignition switch ON, compare the operating sound of the
brake ...
Toyota CH-R Service Manual > Stop Light Switch: Components
COMPONENTS
ILLUSTRATION
*1
COWL SIDE TRIM BOARD LH
*2
FRONT DOOR SCUFF PLATE LH
*3
NO. 1 AIR DUCT
*4
NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
*5
STOP LIGHT SWITCH ASSE ...