Toyota CH-R Service Manual: Installation

Toyota CH-R Service Manual / Door / Hatch / Fuel Lid Opener Switch / Installation

INSTALLATION

PROCEDURE

1. INSTALL FUEL LID OPENER SWITCH

(a) Engage the claws to install the fuel lid opener switch as shown in the illustration.

Install in this Direction

2. INSTALL FUSE BOX OPENING COVER

Click here

3. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

Click here

4. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Click here

5. INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY

Click here

6. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Click here

7. INSTALL COWL SIDE TRIM BOARD LH

Click here

8. INSTALL FRONT DOOR SCUFF PLATE LH

Click here

    Inspection
    INSPECTION PROCEDURE 1. INSPECT FUEL LID OPENER SWITCH (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: ...

    Fuel Lid Opener System
    Parts Location PARTS LOCATION ILLUSTRATION *1 FUEL LID WITH MOTOR LOCK ASSEMBLY *2 NO. 1 ENGINE ROOM RELAY BLOCK - FUEL OPN FUSE ILLUSTR ...

    Other materials:

    Toyota CH-R Service Manual > Front Drive Shaft Assembly: Installation
    INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. INSTALL FRONT DRIVE INBOARD JOINT HOLE SNAP RING LH (for LH Side) (a) Install a new front drive inboard joint hole snap ring ...

    Toyota CH-R Service Manual > Can Communication System: Open in Bus 2 Main Bus Line
    DESCRIPTION There may be an open circuit in one of the CAN main bus lines when the resistance between terminals 18 (CA4H) and 17 (CA4L) of the central gateway ECU (network gateway ECU) is 70 Ω or higher. Symptom Trouble Area Resistance between terminals ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0079