INSPECTION
PROCEDURE
1. INSPECT FUEL LID OPENER SWITCH
|
(a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the fuel lid opener switch. |
|
|
(b) Check that the LED illuminates. (1) Apply battery voltage to the fuel lid opener switch and check that the fuel lid opener switch illuminates. OK:
If the result is not as specified, replace the fuel lid opener switch. |
|
Removal
InstallationToyota CH-R Service Manual > K114 Continuously Variable Transaxle Fluid: Replacement
REPLACEMENT
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration)
that must be performed after parts are removed, installed, or replaced during the
CVT fluid replacement are shown below.
Necessary Procedure After Parts Removed/Installed/Re ...
Toyota CH-R Service Manual > Navigation System: Mute Signal Circuit between Radio Receiver and Telematics Transceiver
DESCRIPTION
The telematics transceiver sends a mute signal to the radio and display receiver
assembly.
The radio and display receiver assembly controls the volume according to the
mute signal from the telematics transceiver.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Depending on the ...