REMOVAL
PROCEDURE
1. REMOVE FRONT DOOR SCUFF PLATE LH
Click here
2. REMOVE COWL SIDE TRIM BOARD LH
Click here
3. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here
4. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY
Click here
5. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
Click here
6. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Click here
7. REMOVE FUSE BOX OPENING COVER
Click here
8. REMOVE FUEL LID OPENER SWITCH
(a) Disengage the claws to remove the fuel lid opener switch as shown in the illustration.
|
Remove in this Direction |
Components
InspectionToyota CH-R Service Manual > Front Seat Cushion Heater: Inspection
INSPECTION
PROCEDURE
1. INSPECT FRONT SEAT CUSHION HEATER ASSEMBLY LH
(a) for TMC Made:
(1) Check the resistance.
Measure the resistance according to the value(s) in the table
below.
Standard Resistance:
Tester Connection
...
Toyota CH-R Service Manual > Seat Position Sensor: Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration)
that must be performed after parts are removed, installed, or replaced during the
seat position airbag sensor removal/installation are shown below.
Necessary Procedure After Par ...