INSTALLATION
PROCEDURE
1. INSTALL STEERING PAD SWITCH ASSEMBLY
(a) Engage the 4 claws and 4 pins to install the steering pad switch assembly.
(b) Install the 2 screws.
(c) Connect connector to the spiral cable with sensor sub-assembly.
2. INSTALL HORN BUTTON ASSEMBLY
Click here
Toyota CH-R Service Manual > Vehicle Stability Control System: Excessive Brake Pedal Travel (No Fluid Leaks and No Air in System)
DESCRIPTION
Depending on the malfunction, the skid control ECU (brake actuator assembly)
prohibits operation of the vehicle stability control system to protect components
and prevent incorrect operation when DTCs are stored.
If the switching solenoid is disabled due to prohibition of the vehic ...
Toyota CH-R Service Manual > Wiper / Washer: Wiper Ecu
Components
COMPONENTS
ILLUSTRATION
*1
WINDSHIELD WIPER RELAY ASSEMBLY
-
-
N*m (kgf*cm, ft.*lbf): Specified torque
-
-
Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (ad ...