INSTALLATION
PROCEDURE
1. INSTALL STEERING HEATER SWITCH
(a) Engage the 2 claws to install the steering heater switch to the fuse box opening cover.
![]() |
Install in this direction |
2. INSTALL FUSE BOX OPENING COVER
Click here
3. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Click here
4. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
Click here
5. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here
6. INSTALL COWL SIDE TRIM BOARD LH
Click here
7. INSTALL FRONT DOOR SCUFF PLATE LH
Click here
Toyota CH-R Service Manual > Vehicle Stability Control System: Open in Stop Light Switch Circuit (C1249)
DESCRIPTION
The skid control ECU (brake actuator assembly) receives stop light switch signals
and uses them to determine whether or not the brakes are applied. DTCs may be stored
if either of the following occurs:
Stop light switch stuck on malfunction.
The accelerator and brake ped ...
Toyota CH-R Service Manual > Can Communication System: Steering Angle Sensor Communication Stop Mode
DESCRIPTION
Detection Item
Symptom
Trouble Area
Steering Angle Sensor Communication Stop Mode
Any of the following conditions are met:
Communication stop for "Spiral cable (Steering Angle Sensor)"
is indicate ...