INSPECTION
PROCEDURE
1. INSPECT STEERING HEATER SWITCH
(a) Check the resistance.
|
(1) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the steering heater switch. |
|
(b) Check that the illumination illuminates.
|
(1) Apply battery voltage between the terminals of the switch, and check the illumination condition of the steering heater switch. Standard:
If the result is not as specified, replace the steering heater switch. |
|
Removal
InstallationToyota CH-R Service Manual > Front Door Courtesy Switch: Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the LH and RH sides.
The procedure described below is for the LH side.
PROCEDURE
1. INSTALL FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY
(a) Using a T30 "TORX" socket wrench, install the front door c ...
Toyota CH-R Service Manual > Safety Connect System: Telematics Transceiver Malfunction (B15A8)
DESCRIPTION
This DTC is set when an error in the EEPROM or PLL IC is detected on the DCM
(Telematics Transceiver) self-check. The EEPROM (Electrically Erasable Programmable
Read-Only Memory) stores the various data to operate the safety connect system.
The PLL IC (Phase-Locked Loop Integrated ...