Toyota CH-R Service Manual: Removal

REMOVAL

PROCEDURE

1. REMOVE FRONT DOOR SCUFF PLATE LH

Click here

2. REMOVE COWL SIDE TRIM BOARD LH

Click here

3. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Click here

4. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Click here

5. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

Click here

6. REMOVE FUSE BOX OPENING COVER

Click here

7. REMOVE STEERING HEATER SWITCH

(a) Disengage the 2 claws to remove the steering heater switch from the fuse box opening cover.

Remove in this direction

    Components
    COMPONENTS ILLUSTRATION *1 COWL SIDE TRIM BOARD LH *2 FRONT DOOR SCUFF PLATE LH *3 FUSE BOX OPENING COVER *4 ...

    Inspection
    INSPECTION PROCEDURE 1. INSPECT STEERING HEATER SWITCH (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: ...

    Other materials:

    Toyota CH-R Service Manual > Horn System: Parts Location
    PARTS LOCATION ILLUSTRATION *1 LOW PITCHED HORN ASSEMBLY *2 HORN RELAY *3 NO. 1 ENGINE ROOM RELAY BLOCK *4 HORN FUSE ILLUSTRATION *1 SPIRAL CABLE SUB-ASSEMBLY ...

    Toyota CH-R Service Manual > Airbag System: Short in Rear Pretensioner Squib RH Circuit (B1920/77-B1923/77)
    DESCRIPTION The rear pretensioner squib RH circuit consists of the airbag sensor assembly and rear seat 3 point type outer belt assembly RH. The airbag sensor assembly uses this circuit to deploy the pretensioner when deployment conditions are met. These DTCs are stored when a malfunction is ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0107