DESCRIPTION
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
Note |
|---|---|---|---|---|
|
B1003 |
ECU Malfunction |
A malfunction in the non-volatile storage of the central gateway ECU (network gateway ECU) is detected. |
Central gateway ECU (network gateway ECU) |
- |
PROCEDURE
|
1. |
RECONFIRM DTC OUTPUT |
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Central Gateway / Trouble Codes.
Body Electrical > Central Gateway > Trouble Codes|
Result |
Proceed to |
|---|---|
|
DTC B1003 is not output from the central gateway ECU (network gateway ECU) |
A |
|
DTC B1003 is output from the central gateway ECU (network gateway ECU) |
B |
| A | |
USE SIMULATION METHOD TO CHECK
|
| B | |
REPLACE CENTRAL GATEWAY ECU (NETWORK GATEWAY ECU) |
Data List / Active Test
Diagnostic Trouble Code ChartToyota CH-R Service Manual > Transmission Control Cable: Adjustment
ADJUSTMENT
PROCEDURE
1. SECURE VEHICLE
(a) Fully apply the parking brake and chock a wheel.
CAUTION:
Make sure to apply the parking brake and chock a wheel before performing
this procedure.
If the vehicle is not secure and the shift lever is moved to N, the
vehicle may sudd ...
Toyota CH-R Service Manual > Rain Sensor: Removal
REMOVAL
PROCEDURE
1. REMOVE RAIN SENSOR COVER
(a) Release the stopper by pulling it out as shown in the illustration.
*a
Stopper
Release
Remove in this Direction
(b) Disconnect the rain sensor with rain sensor ...