REMOVAL
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. REMOVE REAR WHEEL HOUSE FRONT PLATE
Click here
2. REMOVE ROCKER PANEL MOULDING
(a) Apply protective tape around the rocker panel moulding and doors as shown in the illustration.
|
Protective Tape |
- |
- |
(b) Remove the 8 clips.
(c) Remove the 5 screws.
(d) Remove the screws.
|
Remove in this Direction |
(e) Disengage the claw to disconnect the quarter outside moulding LH as shown in the illustration.
(f) Disengage the clips to remove the rocker panel moulding as shown in the illustration.
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Components
DisassemblyToyota CH-R Service Manual > Vehicle Stability Control System: Yaw Rate Sensor Output Value (C1448)
DESCRIPTION
The yaw rate and acceleration sensor is built into the airbag sensor assembly.
The skid control ECU receives signals from the yaw rate and acceleration sensor
(airbag sensor assembly) via CAN communication.
The airbag sensor assembly has a built-in yaw rate and acceleration sensor a ...
Toyota CH-R Service Manual > Navigation System: Telematics Transceiver Disconnected (B15DB)
DESCRIPTION
If the radio and display receiver assembly cannot detect the DCM (telematics
transceiver) for a certain period of time (90 seconds) after the engine switch is
turned on (ACC) and the radio and display receiver assembly confirms that the information
is missing by checking past DCM ...