FAIL-SAFE CHART
If any of the following DTCs are stored, the ECM enters fail-safe mode to allow the vehicle to be driven temporarily.
|
DTC No. |
Fail-safe Operation |
Fail-safe Deactivation Condition |
|---|---|---|
|
P161A |
Generator command is maintained. |
LIN communication system is returned to normal operation. |
Data List / Active Test
Diagnostic Trouble Code ChartToyota CH-R Service Manual > Shift Lever: Inspection
INSPECTION
PROCEDURE
1. INSPECT SHIFT LOCK CONTROL UNIT ASSEMBLY (w/o Smart Key System)
HINT:
If the results of the following inspections are as specified but a malfunction
has occurred, replace the shift lock control unit assembly.
(a) Inspect the wire harness.
(1) Disconnect the ...
Toyota CH-R Service Manual > Continuously Variable Transaxle Assembly(when Using The Engine Support Bridge): Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration)
that must be performed after parts are removed, installed, or replaced during the
continuously variable transaxle assembly removal/installation are shown below.
Necessary Proced ...