INSPECTION
PROCEDURE
1. INSPECT PARK/NEUTRAL POSITION SWITCH
|
*a |
Component without harness connected (Park/Neutral Position Switch) |
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
4 (B) - 9 (L) |
Shift lever in P or N |
Below 1 Ω |
|
Shift lever not in P or N |
10 kΩ or higher |
|
|
1 (RB) - 3 (PL) |
Shift lever in P |
Below 1 Ω |
|
Shift lever not in P |
10 kΩ or higher |
|
|
1 (RB) - 2 (RL) |
Shift lever in R |
Below 1 Ω |
|
Shift lever not in R |
10 kΩ or higher |
|
|
1 (RB) - 8 (NL) |
Shift lever in N |
Below 1 Ω |
|
Shift lever not in N |
10 kΩ or higher |
|
|
1 (RB) - 7 (DL) |
Shift lever in D or M |
Below 1 Ω |
|
Shift lever not in D or M |
10 kΩ or higher |
If the result is not as specified, replace the park/neutral position switch.
Removal
AdjustmentToyota CH-R Service Manual > Power Steering System: Parts Location
PARTS LOCATION
ILLUSTRATION
*A
w/ Toyota Safety Sense P
-
-
*1
ECM
*2
POWER STEERING ECU ASSEMBLY
- POWER STEERING MOTOR
*3
BRAKE ACTUATOR ASSEMBLY
- SKID CONTROL ECU
...
Toyota CH-R Service Manual > Toyota Entune System: DCM Data Signal Circuit between Navigation ECU and DCM
DESCRIPTION
This circuit is used to send and receive signals between the DCM (Telematics
Transceiver) and radio and display receiver assembly.
WIRING DIAGRAM
PROCEDURE
1.
CHECK VEHICLE TYPE
(a) Check vehicle type.
Result
Proceed to
...