REMOVAL
PROCEDURE
1. REMOVE NO. 1 ENGINE UNDER COVER
Click here
2. REMOVE REAR ENGINE UNDER COVER LH
Click here
3. REMOVE NO. 2 CYLINDER HEAD COVER
Click here
4. REMOVE RADIATOR COVER
Click here
5. REMOVE NO. 1 AIR CLEANER INLET
Click here
6. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE
Click here
7. REMOVE AIR CLEANER CASE SUB-ASSEMBLY
Click here
8. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
(a) Move the shift lever to N.
(b) Remove the nut and disconnect the transmission control cable assembly from the control shaft lever. |
|
(c) Remove the clip and disconnect the transmission control cable assembly from the No. 1 transmission control cable bracket.
9. REMOVE PARK/NEUTRAL POSITION SWITCH
(a) Disconnect the connector. |
|
(b) Remove the nut, washer and control shaft lever from the park/neutral position switch. |
|
(c) Using a screwdriver, pry out the lock plate and remove the lock nut and lock plate from the park/neutral position switch. |
|
(d) Remove the 2 bolts and park/neutral position switch from the continuously variable transaxle assembly. |
|
Toyota CH-R Service Manual > Continuously Variable Transaxle System: Dtc Check / Clear
DTC CHECK / CLEAR
NOTICE:
When the diagnosis system is changed from normal mode to check mode or vice versa,
all DTCs and freeze frame data recorded in normal mode are cleared. Before changing
modes, always check and make a note of DTCs and freeze frame data.
HINT:
DTCs which are sto ...
Toyota CH-R Service Manual > Supplemental Restraint Systems: Airbag Cut-off Switch
Components
COMPONENTS
ILLUSTRATION
*1
AIRBAG CUT OFF SWITCH CYLINDER SUB-ASSEMBLY
*2
INSTRUMENT PANEL FINISH END PANEL RH
Removal
REMOVAL
PROCEDURE
1. REMOVE INSTRUMENT PANEL FINISH END PANEL RH
Click here
2. REMOVE AIRBAG CUT O ...