Toyota CH-R Service Manual: On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT PARK/NEUTRAL POSITION SWITCH OPERATION

(a) Apply the parking brake.

(b) Turn the ignition switch to ON.

(c) Depress the brake pedal and check that the engine starts when the shift lever is in N or P, but does not start in any other position.

(d) Check that the back-up light illuminates and the reverse warning buzzer sounds only when the shift lever is in R, but does not function in any other position.

If a malfunction or failure is found, check the park/neutral position switch for continuity.

    Components
    COMPONENTS ILLUSTRATION *1 NO. 1 ENGINE UNDER COVER *2 REAR ENGINE UNDER COVER LH N*m (kgf*cm, ft.*lbf): Specified torque ...

    Removal
    REMOVAL PROCEDURE 1. REMOVE NO. 1 ENGINE UNDER COVER Click here 2. REMOVE REAR ENGINE UNDER COVER LH Click here 3. REMOVE NO. 2 CYLINDER HEAD COVER Click here 4. REMOVE RADIATO ...

    Other materials:

    Toyota CH-R Service Manual > Front Seatback Heater: Installation
    INSTALLATION CAUTION / NOTICE / HINT CAUTION: Be sure to read Precaution thoroughly before servicing. Click here Wear protective gloves. Sharp areas on the parts may injure your hands. HINT: Use the same procedure for the driver side and front passen ...

    Toyota CH-R Service Manual > Vehicle Stability Control System: Acceleration Sensor Internal Circuit (C1419,C1435)
    DESCRIPTION These DTCs are stored when the skid control ECU (brake actuator assembly) receives an internal malfunction signal from the yaw rate and acceleration sensor (airbag sensor assembly). DTC No. Detection Item DTC Detection Condition Trouble A ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0088