Components
COMPONENTS
ILLUSTRATION
*1 |
DOUBLE LOCK DOOR CONTROL RELAY ASSEMBLY |
- |
- |
![]() |
N*m (kgf*cm, ft.*lbf): Specified torque |
- |
- |
Installation
INSTALLATION
PROCEDURE
1. INSTALL DOUBLE LOCK DOOR CONTROL RELAY ASSEMBLY
(a) Connect the connector. |
|
(b) Engage the guide.
(c) Install the double lock door control relay assembly with the bolt.
Torque:
12.5 N·m {127 kgf·cm, 9 ft·lbf}
2. INSTALL INSTRUMENT PANEL SUB-ASSEMBLY
Click here
Removal
REMOVAL
PROCEDURE
1. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY
Click here
2. REMOVE DOUBLE LOCK DOOR CONTROL RELAY ASSEMBLY
(a) Remove the bolt. |
|
(b) Disengage the guide.
(c) Disconnect the connector to remove the double lock door control relay assembly.
Toyota CH-R Service Manual > Vehicle Stability Control System: Dtc Check / Clear
DTC CHECK / CLEAR
DTC CHECK/CLEAR (When Using TECHSTREAM)
(a) Check for DTCs.
(1) Turn the ignition switch off.
(2) Connect the Techstream to the DLC3.
(3) Turn the ignition switch to ON.
(4) Turn the Techstream on.
(5) Read the DTCs following the prompts on the Techstream. Enter the followin ...
Toyota CH-R Service Manual > Immobiliser System(w/ Smart Key System): Data List / Active Test
DATA LIST / ACTIVE TEST
DATA LIST
NOTICE:
In the table below, the values listed under "Normal Condition" are reference
values. Do not depend solely on these reference values when deciding whether a part
is faulty or not.
HINT:
Using the Techstream to read the Data List allows the ...