Toyota CH-R Service Manual: Problem Symptoms Table

PROBLEM SYMPTOMS TABLE

HINT:

  • Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  • Inspect the fuses and relays related to this system before inspecting the suspected areas below.
Continuously Variable Transaxle System

Symptom

Suspected Area

Link

No gear change by moving shift lever to "+" or "-" from M

Refer to Transmission Control Switch Circuit

SPORT mode does not operate

CAN communication system

Combination meter assembly

Steering pad switch assembly

ECM

    Initialization
    INITIALIZATION NOTICE: Performing Reset Memory will clear the learned value of the yaw rate and acceleration sensor (deceleration sensor zero point calibration) and the CVT oil press ...

    Terminals Of Ecm
    TERMINALS OF ECM ECM HINT: The standard voltage and resistance of each ECM terminal is shown in the table below. In the table, first follow the information under "Condition". Look un ...

    Other materials:

    Toyota CH-R Service Manual > Automatic High Beam System: Parts Location
    PARTS LOCATION ILLUSTRATION *1 NO. 1 INTEGRATION RELAY - H-LP RH RELAY - H-LP LH RELAY *2 HEADLIGHT UNIT ASSEMBLY RH *3 HEADLIGHT UNIT ASSEMBLY LH *4 FORWARD RECOGNITION CAMERA *5 ...

    Toyota CH-R Service Manual > Can Communication System: Check Bus 1 Line for Short to GND
    DESCRIPTION There may be a short circuit between one of the CAN bus lines and GND when there is no resistance between terminal 23 (CA1H) of the central gateway ECU (network gateway ECU) and terminal 4 (CG) of the DLC3, or terminal 8 (CA1L) of the central gateway ECU (network gateway ECU) and ...

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2025 Copyright www.tochr.net
    0.0564