Toyota CH-R Service Manual: Inspection

Toyota CH-R Service Manual / Drive Shaft / Propeller Shaft / Front Drive Shaft Assembly / Inspection

INSPECTION

PROCEDURE

1. INSPECT FRONT DRIVE SHAFT ASSEMBLY

(a) Check that there is no excessive play in the radial direction of the outboard joint.

(b) Check that the inboard joint slides smoothly in the thrust direction.

(c) Check that there is no excessive play in the radial direction of the inboard joint.

(d) Check the boots for damage.

(e) Check whether each drive shaft dimension (A) is within specification.

Dimension (A):

LH Side

590.5 mm (1.94 ft.)

RH Side

887.1 mm (2.91 ft.)

NOTICE:

Keep the drive shaft assembly level during inspection.

*a

LH Side

*b

RH Side
    Disassembly
    DISASSEMBLY PROCEDURE 1. SEPARATE FRONT NO. 2 AXLE INBOARD JOINT BOOT CLAMP (a) Secure the drive shaft in a vise between aluminum plates. NOTICE: Do not overtighten the vise. (b) Usin ...

    Reassembly
    REASSEMBLY PROCEDURE 1. INSTALL FRONT DRIVE SHAFT DUST COVER LH (a) Using a steel plate and a press, install a new front drive shaft dust cover LH. NOTICE: The dus ...

    Other materials:

    Toyota CH-R Service Manual > Cellular Communication: Dcm(telematics Transceiver)
    Components COMPONENTS ILLUSTRATION *1 DCM (TELEMATICS TRANSCEIVER) - - N*m (kgf*cm, ft.*lbf): Specified torque - - Removal REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjus ...

    Toyota CH-R Service Manual > Vehicle Stability Control System: Open in Front Speed Sensor RH (C1330-C1467)
    DESCRIPTION Each speed sensor detects wheel speed and sends signals to the skid control ECU (brake actuator assembly). These signals are used by the ABS. HINT: The output voltage values shown below are for when the vehicle wire harnesses are connected to the skid control ECU (brake actuator a ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0073