REMOVAL
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. REMOVE REAR WHEEL
Click here
2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY
Click here
3. REMOVE REAR DISC
Click here
4. DISCONNECT SKID CONTROL SENSOR WIRE
|
(a) Using a screwdriver with its tip wrapped in protective tape, disconnect the skid control sensor connector from the rear axle hub and bearing assembly. NOTICE: Be careful not to damage the rear axle hub and bearing assembly and connector cover. |
|
5. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY
|
(a) Remove the 4 bolts, rear axle hub and bearing assembly and rear disc brake dust cover sub-assembly from the rear axle carrier sub-assembly. |
|
Installation
Rear Axle Hub BoltToyota CH-R Owners Manual > Operating the lights and wipers: Headlight switch
The headlights can be operated manually or automatically.
Operating instructions
Turning the
switch
turns on the lights as follows:
For U.S.A.
The headlights, side marker, parking lights, daytime running lights and so on
turn on and off automatically.
(When the engine switch ...
Toyota CH-R Service Manual > Washer Level Warning Switch: Inspection
INSPECTION
PROCEDURE
1. INSPECT LEVEL WARNING SWITCH ASSEMBLY
HINT:
This check should be performed with the level warning switch assembly installed
on the washer jar.
(a) Fill the washer jar with washer fluid.
...