INSTALLATION
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY
(a) Install the rear axle hub and bearing assembly and rear disc brake dust cover sub-assembly to the rear axle carrier sub-assembly with the 4 bolts.
Torque:
90 N·m {918 kgf·cm, 66 ft·lbf}
2. INSTALL REAR DISC
Click here
3. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY
Click here
4. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY
Click here
5. REMOVE REAR DISC
Click here
6. INSPECT REAR AXLE HUB BEARING LOOSENESS
Click here
7. INSPECT REAR AXLE HUB RUNOUT
Click here
8. INSTALL REAR DISC
Click here
9. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY
Click here
10. CONNECT SKID CONTROL SENSOR WIRE
(a) Connect the skid control sensor connector to the rear axle hub and bearing assembly.
11. INSTALL REAR WHEEL
Click here
12. CHECK FOR SPEED SENSOR SIGNAL
Click here
On-vehicle Inspection
RemovalToyota CH-R Service Manual > Navigation System: Cursor or Map Rotates when Vehicle Stopped
PROCEDURE
1.
CHECK CONDITION
(a) Check with the customer if the vehicle has been turned by a turntable.
OK:
Vehicle has not been turned by a turntable.
HINT:
If the vehicle is turned on a turntable with the engine switch on (IG),
the syst ...
Toyota CH-R Service Manual > Navigation System: Reverse Signal Circuit between Radio Receiver Assembly and Navigation ECU
DESCRIPTION
This circuit includes the navigation ECU and radio and display receiver assembly.
WIRING DIAGRAM
PROCEDURE
1.
CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NAVIGATION
ECU)
(a) Disconnect the F130 radio and display receiver a ...