ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. REMOVE REAR WHEEL
Click here
2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY
Click here
3. REMOVE REAR DISC
Click here
4. INSPECT REAR AXLE HUB BEARING LOOSENESS
|
(a) Using a dial indicator, check for looseness near the center of the rear axle hub. Maximum Looseness: 0.05 mm (0.00196 in.) NOTICE:
HINT: If the looseness exceeds the maximum, replace the rear axle hub and bearing assembly. |
|
5. INSPECT REAR AXLE HUB RUNOUT
|
(a) Using a dial indicator, check for runout on the surface of the rear axle hub outside the rear axle hub bolts. Maximum Runout: 0.05 mm (0.00196 in.) NOTICE:
HINT: If the runout exceeds the maximum, replace the rear axle hub and bearing assembly. |
|
6. INSTALL REAR DISC
Click here
7. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY
Click here
8. INSTALL REAR WHEEL
Click here
Components
InstallationToyota CH-R Service Manual > Power Steering System: PIG Power Supply Voltage (C1552,C1554)
DESCRIPTION
If a problem occurs in the system, the power source relay circuit and the motor
relay circuit are shut off to stop power assist. The ECU must be replaced when there
is a problem with the relays because the relays are built into the ECU.
DTC No.
Detection Item
...
Toyota CH-R Service Manual > Audio And Visual System(for Radio And Display Type): Lost Communication with Meter (B1324)
DESCRIPTION
This DTC is stored when a communication error occurs between the radio and display
receiver assembly and combination meter assembly.
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
B1324
Lost Communic ...