CAUTION / NOTICE / HINT
HINT:
*: Use the Techstream.
PROCEDURE
|
1. |
VEHICLE BROUGHT TO WORKSHOP |
|
|
2. |
CUSTOMER PROBLEM ANALYSIS |
(a) Interview the customer and confirm the problem.
Click here
|
|
3. |
INSPECT BATTERY VOLTAGE |
Standard Voltage:
11 to 14 V
|
|
4. |
CHECK DTC AND FREEZE FRAME DATA* |
(a) Check and record DTCs and freeze frame data.
for DTC Check / Clear: Click here
for Freeze Frame Data: Click here
(b) Clear the DTCs and freeze frame data.
for DTC Check / Clear: Click here
(c) Recheck for DTCs.
(1) Reconfirm the DTCs based on the recorded DTCs and freeze frame data.
Chassis > ABS/VSC/TRAC/EPB > Trouble Codes(2) Try to reproduce the problem symptoms based on the recorded DTCs and freeze frame data, and then check if the DTCs are output again.
|
Result |
Proceed to |
|---|---|
|
DTCs are not output. (Problem symptom occurs.) |
A |
|
DTCs are output. |
B |
|
DTCs are not output. (Problem symptom does not occur.) |
C |
HINT:
| B | |
GO TO DIAGNOSTIC TROUBLE CODE CHART
|
| C | |
USE SIMULATION METHOD TO CHECK
|
|
|
5. |
PROBLEM SYMPTOMS TABLE |
(a) Proceed to Problem Symptoms Table.
Click here
|
Result |
Proceed to |
|---|---|
|
Fault is not listed in Problem Symptoms Table. |
A |
|
Fault is listed in Problem Symptoms Table. |
B |
| B | |
GO TO STEP 7 |
|
|
6. |
OVERALL ANALYSIS AND TROUBLESHOOTING* |
(a) Refer to Terminals of ECU.
Click here
(b) Refer to Data List / Active Test.
Click here
|
|
7. |
REPAIR OR REPLACE |
|
|
8. |
CONFIRMATION TEST |
| NEXT | |
END |
System Diagram
Test Mode ProcedureToyota CH-R Service Manual > Can Communication System: How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
PRECAUTIONS WHEN TROUBLESHOOTING
NOTICE:
Because the order of diagnosis is important to allow correct diagnosis,
make sure to begin troubleshooting using How to Proceed with Troubleshooting
when CAN communication system related DTCs are output.
If the C ...
Toyota CH-R Service Manual > Smart Key System(for Entry Function): Open in Front Passenger Side Electrical Antenna Circuit (B27A2)
DESCRIPTION
The certification ECU (smart key ECU assembly) generates a request signal and
transmits the signal to the front door outside handle assembly RH (electrical key
antenna) at intervals of 0.25 seconds. For the front door outside handle assembly
RH (electrical key antenna) to detect w ...