Toyota CH-R Service Manual: On-vehicle Inspection

Toyota CH-R Service Manual / Seat Belt / Rear Seat Outer Belt Assembly / On-vehicle Inspection

ON-VEHICLE INSPECTION

CAUTION / NOTICE / HINT

CAUTION:

Be sure to correctly follow the removal and installation procedures for the rear 3 point type seat outer belt assembly.

PROCEDURE

1. INSPECT REAR 3 POINT TYPE SEAT OUTER BELT ASSEMBLY (for Vehicle not Involved in Collision)

(a) Visually check for defects with the rear 3 point type seat outer belt assembly installed to the vehicle.

(1) The defects to be checked are as follows:

Cuts on the rear 3 point type seat outer belt assembly
Small cracks on the rear 3 point type seat outer belt assembly
Significant discoloration on the rear 3 point type seat outer belt assembly

OK:

No defects are found.

HINT:

If any defects are found, replace the rear 3 point type seat outer belt assembly with a new one.

2. INSPECT REAR 3 POINT TYPE SEAT OUTER BELT ASSEMBLY (for Vehicle Involved in Collision)

(a) Visually check for defects with the rear 3 point type seat outer belt assembly removed from the vehicle.

(1) The defects to be checked are as follows:

Cuts on the rear 3 point type seat outer belt assembly
Small cracks on the rear 3 point type seat outer belt assembly
Significant discoloration on the rear 3 point type seat outer belt assembly
Cracks or other damage on the connector

OK:

No defects are found.

HINT:

If any defects are found, replace the rear 3 point type seat outer belt assembly with a new one.

Components

COMPONENTS ILLUSTRATION *A w/ Package Tray Trim *B w/ Tonneau Cover *1 PACKAGE TRAY TRIM PANEL ASSEMBLY *2 ...

REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during ...

Other materials:

Toyota CH-R Service Manual > Airbag System: TC and CG Terminal Circuit
DESCRIPTION DTC output mode is set by connecting terminals TC and CG of the DLC3. DTCs are displayed by blinking of the SRS warning light. HINT: When multiple warning lights in the combination meter blink continuously, a short to ground in the wiring or an ECU connected to terminal T ...

Toyota CH-R Service Manual > Vehicle Stability Control System: Terminals Of Ecu
TERMINALS OF ECU TERMINALS OF ECU *a Component without harness connected (Skid Control ECU (Brake Actuator Assembly)) - - Terminal No. (Symbol) Terminal Description 1 (+BM) ABS motor relay ...

Toyota CH-R Service Manual: On-vehicle Inspection

Components

Removal

Other materials:

Toyota C-HR (AX20) 2023-2026 Owner's Manual

Toyota CH-R Owners Manual

Toyota CH-R Service Manual