DESCRIPTION
The skid control ECU (brake actuator assembly) stores this DTC if malfunctions are found in a circuit inside the ECU by self diagnosis.
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
|---|---|---|---|
|
C1300 |
Skid Control ECU Malfunction |
Internal failure of the skid control ECU (brake actuator assembly). |
Skid control ECU (brake actuator assembly) |
PROCEDURE
|
1. |
REPLACE BRAKE ACTUATOR ASSEMBLY |
(a) Replace the skid control ECU (brake actuator assembly).
Click here
HINT:
This DTC is output when the skid control ECU (brake actuator assembly) detects a malfunction in an internal circuit.
(b) Perform system variant learning.
Click here
(c) Perform the sensor check using the Test Mode procedure.
Click here
|
Tester Display |
|---|
|
Test Mode |
| NEXT | |
END |
Error in Matching of ECUs (C1288)
Open in Front Speed Sensor RH (C1330-C1467)Toyota CH-R Service Manual > Automatic High Beam System: Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
Automatic High Beam System
DTC No.
Detection Item
Link
B124B
Automatic High Beam System
B124C
Automatic High Beam Camera
U ...
Toyota CH-R Service Manual > Rear Wheel Alignment: Adjustment
ADJUSTMENT
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration)
that must be performed after completing the rear wheel alignment procedure are shown
below.
Necessary Procedures After Procedure Performed
Replaced Part or Perfor ...