If the engine will not start even though correct starting procedures are being followed, consider each of the following points:
The engine will not start even though the starter motor operates normally.
One of the following may be the cause of the problem:
Refuel the vehicle.
Try to restart the engine again following correct starting procedures.
The starter motor turns over slowly, the interior lights and headlights are dim, or the horn does not sound or sounds at a low volume.
One of the following may be the cause of the problem:
The starter motor does not turn over (vehicles with a smart key system)
The engine starting system may be malfunctioning due to an electrical problem such as electronic key battery depletion or a blown fuse.
However, an interim measure is available to start the engine.
The starter motor does not turn over, the interior lights and headlights do not turn on, or the horn does not sound.
One of the following may be the cause of the problem:
Contact your Toyota dealer if the problem cannot be repaired, or if repair procedures are unknown.
Emergency start function (vehicles with a smart key system)
When the engine does not start, the following steps can be used as an interim measure to start the engine if the engine switch is functioning normally:
1. Set the parking brake.
2. Shift the shift lever to P.
3. Turn the engine switch to ACCESSORY mode.
4. Press and hold the engine switch for about 15 seconds while depressing the brake pedal firmly.
Even if the engine can be started using the above steps, the system may be malfunctioning. Have the vehicle inspected by your Toyota dealer.
Installing the spare tire
If the electronic key does not operate properly (vehicles with a smart key system)Toyota CH-R Service Manual > Axle And Differential: Steering Knuckle
Components
COMPONENTS
ILLUSTRATION
*1
FRONT LOWER BALL JOINT ASSEMBLY
*2
STEERING KNUCKLE
*3
FRONT AXLE HUB SUB-ASSEMBLY
*4
FRONT DISC BRAKE DUST COVER
*5
COTTER PIN
...
Toyota CH-R Service Manual > Smart Key System(for Entry Function): Back Door Entry Unlock Function does not Operate
DESCRIPTION
If the entry unlock function does not operate for the back door only, but the
entry lock function operates, the request code is being transmitted properly from
the back door. In this case, there may be a problem related to the open switch (connection
between the back door opener s ...