Toyota CH-R Service Manual: Image from Camera for Rear View Monitor is Abnormal

Toyota CH-R Service Manual / Park Assist / Monitoring / Rear View Monitor System / Image from Camera for Rear View Monitor is Abnormal

DESCRIPTION

The video signal of the rear television camera assembly is transmitted to the radio and display receiver assembly.

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:

  • When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occur:
    • A communication malfunction DTC is stored.
    • The radio and display receiver assembly may not operate normally.

PROCEDURE

1.

CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - REAR TELEVISION CAMERA ASSEMBLY)

Click here

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

OK

2.

INSPECT RADIO AND DISPLAY RECEIVER ASSEMBLY

Click here

NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

OK

3.

INSPECT REAR TELEVISION CAMERA ASSEMBLY

Click here

OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPLACE REAR TELEVISION CAMERA ASSEMBLY

    Back Camera Disconnected (C1622)
    DESCRIPTION This DTC is stored if the radio and display receiver assembly judges that the signals or signal lines between the radio and display receiver assembly and the rear television camera as ...

    Television Camera
    Components COMPONENTS ILLUSTRATION *1 REAR TELEVISION CAMERA ASSEMBLY - - N*m (kgf*cm, ft.*lbf): Specified torque ...

    Other materials:

    Toyota CH-R Service Manual > Air Conditioning System(for Automatic Air Conditioning System With Side-mounted Air Conditioner Pressure Sensor): Communication Malfunction (Bus Ic) (B1497)
    DESCRIPTION The air conditioning harness assembly connects the air conditioning amplifier assembly and the servo motors. The air conditioning amplifier assembly supplies power and sends operation instructions to each servo motor through the air conditioning harness assembly. Each servo motor ...

    Toyota CH-R Service Manual > Vehicle Stability Control System: Slip Indicator Light Remains ON
    DESCRIPTION The skid control ECU (brake actuator assembly) is connected to the combination meter assembly via CAN communication. The slip indicator light blinks during VSC and/or TRAC operation. If a malfunction is detected, the slip indicator light comes on to warn the driver. Click here ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0068