Toyota CH-R Service Manual: Inspection

INSPECTION

PROCEDURE

1. INSPECT FRONT NO. 1 SPEAKER ASSEMBLY

(a) Check the resistance.

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

1 (+) - 2 (-)

Always

4.0 Ω

If the result is not as specified, replace the front No. 1 speaker assembly.

*a

Component without harness connected

(Front No. 1 Speaker Assembly)

    Removal
    REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. REMOVE FRONT DOOR INSIDE HANDLE ...

    Installation
    INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL FRONT NO. 1 SPEAKE ...

    Other materials:

    Toyota CH-R Service Manual > Brake Booster: Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the brake booster assembly removal/installation are shown below. Necessary Procedure After Parts Re ...

    Toyota CH-R Service Manual > Outer Rear View Mirror: Inspection
    INSPECTION PROCEDURE 1. INSPECT OUTER REAR VIEW MIRROR ASSEMBLY LH (a) Check the operation of the mirror surface. (1) Apply voltage and check the operation of the outer rear view mirror assembly LH. OK: Battery Connection Specified Condit ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0085