Toyota CH-R Service Manual: Diagnosis System

Toyota CH-R Service Manual / Theft Deterrent / Keyless Entry / Smart Key System(for Start Function) / Diagnosis System

DIAGNOSIS SYSTEM

DESCRIPTION

(a) Smart key system (for Start Function) data and Diagnostic Trouble Codes (DTCs) can be read through the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the Techstream to check for malfunctions and perform repairs.

CHECK DLC3

(a) Check the DLC3.

Click here

INSPECT BATTERY VOLTAGE

(a) Measure the battery voltage.

Standard Voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery.

    Problem Symptoms Table
    PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are lis ...

    Terminals Of Ecu
    TERMINALS OF ECU CHECK CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) (a) Disconnect the M66, M67 and F1 certification ECU (smart key ECU assembly) connectors. (b) Measure the voltage and resistanc ...

    Other materials:

    Toyota CH-R Service Manual > Front Drive Shaft Assembly: Reassembly
    REASSEMBLY PROCEDURE 1. INSTALL FRONT DRIVE SHAFT DUST COVER LH (a) Using a steel plate and a press, install a new front drive shaft dust cover LH. NOTICE: The dust cover should be completely installed. Be careful not to damage the front drive shaft dust co ...

    Toyota CH-R Service Manual > Pre-collision System: Skid Control Buzzer Circuit (C1A4A)
    DESCRIPTION The millimeter wave radar sensor assembly is connected to the forward recognition camera via CAN communication. The millimeter wave radar sensor assembly operates the pre-collision alarm by sending a buzzer request signal to the pre-collision city buzzer. If the millimeter wave ra ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0079