Toyota CH-R Service Manual: Problem Symptoms Table

HINT:

• Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
• Inspect the fuses and relays related to the system before inspecting the suspected areas below.
• If the problem occurs in certain locations or times of day, the possibility of wave interference is high.
• If a malfunction occurred after optional components were installed by the dealer, check if there is wave interference from the components.

Operation Check

OPERATION CHECK NOTICE: Make sure that the smart key system (for Start Function) has not been canceled before performing this inspection. Click here OPERATION DESCRIPTION (a) Push-button star ...

Diagnosis System

DIAGNOSIS SYSTEM DESCRIPTION (a) Smart key system (for Start Function) data and Diagnostic Trouble Codes (DTCs) can be read through the Data Link Connector 3 (DLC3) of the vehicle. When the system ...

Other materials:

Toyota CH-R Service Manual > Blind Spot Monitor System: Slave Module Horizontal Axis Misalignment (C1AC2)
DESCRIPTION This DTC is stored when the angle of the blind spot monitor sensor RH (Slave) deviates more than the allowable range from the horizontal axis. HINT: If a drum tester such as a speedometer tester, brake/speedometer combination tester or chassis dynamometer is used with th ...

Toyota CH-R Service Manual > Vehicle Stability Control System: Acceleration Sensor Stuck Malfunction (C1243,C1245)
DESCRIPTION The skid control ECU (brake actuator assembly) receives signals from the yaw rate and acceleration sensor (airbag sensor assembly) via CAN communication. The airbag sensor assembly has a built-in yaw rate and acceleration sensor and detects the vehicle's condition using 2 circu ...