Toyota CH-R Service Manual: Illumination for Panel Switch does not Come on with Tail Switch ON

NOTICE:

• Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.

  Click here

• When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occurs:
  • A communication malfunction DTC may be stored.
  • The radio and display receiver assembly may not operate normally.

HINT:

• This display is updated once per second. As a result, it is normal for the display to lag behind the actual switch operation.
• Make sure to move the vehicle to a bright area before performing an operation check with the light control switch in the AUTO position.

Radio Broadcast cannot be Received or Poor Reception

WIRING DIAGRAM for TMMT Made for TMC Made CAUTION / NOTICE / HINT NOTICE: Depending on the parts that are replaced during vehicle inspection or maintenance, performing initializat ...

Display does not Dim when Light Control Switch is Turned ON

CAUTION / NOTICE / HINT NOTICE: Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be neede ...

Other materials:

Toyota CH-R Service Manual > Power Window Control System: Auto Up Operation does not Fully Close Power Window (Jam Protection Function is Activated)
DESCRIPTION If a door glass does not slide smoothly or a power window regulator motor assembly or door window regulator sub-assembly does not operate smoothly, the jam protection function may be triggered automatically, resulting in the auto up operation being unable to fully close the power ...

Toyota CH-R Service Manual > Smart Key System(for Start Function): Engine/Power Switch Malfunction (B2278)
DESCRIPTION This DTC is stored when the SSW1 contact signal and SSW2 contact signal, which are detected when the engine switch is operated, do not match. DTC No. Detection Item DTC Detection Condition Trouble Area Note B2278 ...