Toyota CH-R Service Manual: Display does not Dim when Light Control Switch is Turned ON

NOTICE:

• Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.

  Click here

• When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occurs:
  • A communication malfunction DTC may be stored.
  • The radio and display receiver assembly may not operate normally.

HINT:

• The display is updated once per second. It is normal for the display to lag behind the actual switch operation.
• Make sure to move the vehicle to a bright area before performing an operation check with the light control switch in the AUTO position.

Illumination for Panel Switch does not Come on with Tail Switch ON

CAUTION / NOTICE / HINT NOTICE: Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be neede ...

Panel Switches do not Function

CAUTION / NOTICE / HINT NOTICE: Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be neede ...

Other materials:

Toyota CH-R Service Manual > Can Communication System: Restraints Occupant Classification System Module Communication Stop Mode
DESCRIPTION Detection Item Symptom Trouble Area Restraints Occupant Classification System Module Communication Stop Mode Any of the following conditions are met: Communication stop for "Occupant Detection" is indic ...

Toyota CH-R Service Manual > Condenser: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the condenser removal/installation are shown below. Necessary Procedure After Parts Removed/Install ...