DESCRIPTION
These DTCs are stored when a malfunction occurs in the radio and display receiver assembly.
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
---|---|---|---|
B1551 |
HD Radio Tuner Malfunction |
When any of the following conditions is met:
|
Radio and display receiver assembly |
B158D |
Video Signal Stoppage |
The internal video signal of the radio and display receiver assembly is interrupted |
Radio and display receiver assembly |
B15A0 |
LAN Master Malfunction |
When either of the following conditions is met:
|
Radio and display receiver assembly |
B15B0 |
Display Screen Malfunction |
Picture circuit (TFT unit) malfunction |
Radio and display receiver assembly |
B15B3 |
Radio Tuner Malfunction |
When any of the following conditions is met:
|
Radio and display receiver assembly |
B15B7 |
Bluetooth Module Malfunction |
"Bluetooth" module malfunction |
Radio and display receiver assembly |
B15BA |
XM Tuner Malfunction |
When either condition below is met:
|
Radio and display receiver assembly |
CAUTION / NOTICE / HINT
NOTICE:
Click here
PROCEDURE
1. |
CHECK DTC |
(a) Clear the DTCs.
Body Electrical > Navigation System > Clear DTCs(b) Recheck for DTCs and check that no DTCs are output.
Body Electrical > Navigation System > Trouble CodesOK:
No DTCs are output.
OK | ![]() |
USE SIMULATION METHOD TO CHECK |
NG | ![]() |
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY |
Toyota CH-R Service Manual > Air Conditioning Amplifier: Installation
INSTALLATION
PROCEDURE
1. INSTALL AIR CONDITIONING AMPLIFIER ASSEMBLY
(a) for VALEO Made:
(1) Connect each connector.
(2) Engage the guides to install the air conditioning amplifier assembly as shown
in the illustration.
Install in this Direction
(3) Install t ...
Toyota CH-R Service Manual > Automatic Headlight Beam Level Control System: Height Control Sensor Data Out of Range When Initializing (B2452)
DESCRIPTION
The headlight ECU sub-assembly LH stores this DTC if the sensor value received
from the rear height control sensor sub-assembly LH is out of range when performing
initialization of the headlight ECU sub-assembly LH; for example, the vehicle is
not level or being jack up.
...