Toyota CH-R Service Manual: GPS Antenna Connection Malfunction(short) (B15C0,B15C1)

NOTICE:

• Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.

  Click here

• When replacing the navigation ECU, always replace it with a new one. If a navigation ECU which was installed to another vehicle is used, the following may occur:
  • A communication malfunction DTC is stored.
  • The radio and display receiver assembly may not operate normally.
• Check that the antenna cord sub-assembly (for navigation antenna) is properly installed and does not have any sharp bends, pinching or loose connections before performing following procedure.

  Click here

Speaker Output Short (B15C3)

DESCRIPTION This DTC is stored when a malfunction occurs in the speakers. DTC No. Detection Item DTC Detection Condition Trouble Area B15 ...

AV Signal Stoppage (Low Battery Voltage) (B158F)

DESCRIPTION This DTC is stored when a video or audio signal is interrupted due to battery voltage input to the radio and display receiver assembly dropping temporarily. DTC No. ...

Other materials:

Toyota CH-R Service Manual > Automatic High Beam System: Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not. HINT: Using the Techstream to read the Data List allows the ...

Toyota CH-R Service Manual > Occupant Classification Ecu: On-vehicle Inspection
ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT CAUTION: Be sure to correctly follow the removal and installation procedures for the occupant detection ECU. PROCEDURE 1. INSPECT OCCUPANT DETECTION ECU (for Vehicle not Involved in Collision) (a) Perform a diagnostic system check. Click here ...