INSTALLATION
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. INSTALL HEADLIGHT ASSEMBLY
(a) Temporarily install the headlight assembly as shown in the illustration.
|
Install in this Direction |
(b) Install the headlight assembly with the bolt and 3 screws.
Torque:
Bolt :
5.4 N·m {55 kgf·cm, 48 in·lbf}
(c) Connect the connector and raise the connector lock lever to engage the claw and lock the connector as shown in the illustration.
|
*a |
Connector Lock Lever |
|
Install in this Direction |
(d) Remove the protective tape.
2. INSTALL FRONT BUMPER ASSEMBLY
Click here
3. PERFORM INITIALIZATION
Click here
4. ADJUST HEADLIGHT AIMING
Click here
Adjustment
ReassemblyToyota CH-R Service Manual > Charging System: Fail-safe Chart
FAIL-SAFE CHART
If any of the following DTCs are stored, the ECM enters fail-safe mode to allow
the vehicle to be driven temporarily.
DTC No.
Fail-safe Operation
Fail-safe Deactivation Condition
P161A
Generator command is maintained.
...
Toyota CH-R Service Manual > Ptc Heater Assembly: Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT DOOR SCUFF PLATE LH
Click here
2. REMOVE COWL SIDE TRIM BOARD LH
Click here
3. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here
4. REMOVE NO. 1 AIR DUCT
Click here
5. REMOVE NO. 2 HEATER COVER (for VALEO Made)
( ...