Toyota CH-R Service Manual: On-vehicle Inspection

ON-VEHICLE INSPECTION

CAUTION / NOTICE / HINT

CAUTION:

Be sure to correctly follow the removal and installation procedures for the side airbag sensors.

PROCEDURE

1. INSPECT SIDE AIRBAG SENSOR (for Vehicle not Involved in Collision)

(a) Perform a diagnostic system check.

Click here

2. INSPECT SIDE AIRBAG SENSOR (for Vehicle Involved in Collision and Airbag not Deployed)

(a) Perform a diagnostic system check.

Click here

(b) Visually check the side airbag sensors for defects if a center pillar of the vehicle or the area around a center pillar is damaged.

HINT:

The defects are as follows:

  • Cracks in the sensor housing
  • Dents in the sensor housing
  • Chips in the sensor housing
  • Cracks or other damage to the connector
  • Damage to the serial number

OK:

No defects are found.

If any defects are found, replace the side airbag sensor with a new one.

3. INSPECT SIDE AIRBAG SENSOR (for Vehicle Involved in Collision and Airbag is Deployed)

(a) When airbags have deployed as the result of a collision, be sure to replace all side airbag sensors in the damaged areas (anywhere in need of repair).

(b) Visually check the side airbag sensors in undamaged areas for defects.

HINT:

The defects are as follows:

  • Cracks in the sensor housing
  • Dents in the sensor housing
  • Chips in the sensor housing
  • Cracks or other damage to the connector
  • Damage to the serial number

OK:

No defects are found.

If any defects are found or a side airbag sensor has detected a major collision, replace the side airbag sensor with a new one.

    Components
    COMPONENTS ILLUSTRATION *A w/ Rear Seat Side Airbag *B w/o Rear Seat Side Airbag *1 CENTER PILLAR LOWER GARNISH * ...

    Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during th ...

    Other materials:

    Toyota CH-R Service Manual > Tire Pressure Warning System: No Signal from Transmitter ID1 (C2121/21-C2125/25,C2181/81-C2185/85)
    DESCRIPTION The tire pressure warning valve and transmitters that are installed in the tire and wheel assemblies measure the tire pressures. The measured values are transmitted to the tire pressure warning ECU and receiver in the vehicle as radio waves. The ECU compares the measured tire pres ...

    Toyota CH-R Service Manual > Airbag System: Side Airbag Sensor Assembly No.2 (LH) (B163A/3A)
    DESCRIPTION The side collision sensor LH circuit (bus 2) consists of the airbag sensor assembly and floor side airbag sensor LH. The floor side airbag sensor LH detects impacts to the vehicle and sends signals to the airbag sensor assembly to determine if the airbags and pretensioners should ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0081