TERMINALS OF ECU
OCCUPANT DETECTION ECU
Terminal No. (Symbol) |
Wiring Color |
Terminal Description |
Condition |
Specified Condition |
---|---|---|---|---|
Y5-1 (SVC1) - Y5-5 (SGD1) |
R - G |
Front in weight detection sensor sub-assembly power supply |
Ignition switch ON |
11 to 14 V |
Y5-2 (SVC3) - Y5-6 (SGD3) |
GR - W |
Rear in weight detection sensor sub-assembly power supply |
Ignition switch ON |
11 to 14 V |
Y5-3 (SIG1) - Y5-5 (SGD1) |
P - G |
Front in weight detection sensor sub-assembly signal |
Ignition switch ON |
Pulse generation |
Y5-4 (SIG3) - Y5-6 (SGD3) |
SB - W |
Rear in weight detection sensor sub-assembly signal |
Ignition switch ON |
Pulse generation |
Y5-5 (SGD1) - Y6-10 (GND) |
G - W-B |
Front in weight detection sensor sub-assembly ground |
Always |
Below 1 V |
Y5-6 (SGD3) - Y6-10 (GND) |
W - W-B |
Rear in weight detection sensor sub-assembly ground |
Always |
Below 1 V |
Y6-4 (CANL) - Y6-10 (GND) |
SB - W-B |
CAN communication line |
Ignition switch ON |
Pulse generation |
Y6-5 (CANH) - Y6-10 (GND) |
R - W-B |
CAN communication line |
Ignition switch ON |
Pulse generation |
Y6-6 (IG2) - Y6-10 (GND) |
B - W-B |
Power source |
Ignition switch ON |
11 to 14 V |
Y6-7 (BSW) - Y6-9 (BGND) |
G - P |
Passenger side buckle switch signal |
Always |
Pulse generation |
Y6-9 (BGND) - Y6-10 (GND) |
P - W-B |
Passenger side buckle switch ground |
Always |
Below 1 V |
Y6-10 (GND) - Body ground |
W-B - Body ground |
Ground |
Always |
Below 1 V |
Toyota CH-R Service Manual > Seat Belt Warning System(w/ Occupant Classification System): Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
NOTICE:
When replacing the combination meter assembly, always replace it with a new one.
If a combination meter assembly which was installed to another vehicle is used,
the information stored in it will not match the information from the vehicle and
a DTC may be stored ...
Toyota CH-R Service Manual > Front Door Outside Moulding: Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedures listed below are for the LH side.
PROCEDURE
1. INSTALL FRONT DOOR OUTSIDE MOULDING
(a) Remove the peeling paper from the face of the outside moulding retainer.
HINT:
Af ...