Toyota CH-R Service Manual: Removal

REMOVAL

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH and LH sides.
  • The procedures listed below are for the LH side.

PROCEDURE

1. REMOVE FRONT DOOR OUTSIDE MOULDING

(a) Apply protective tape around the front door outside moulding.

Protective tape

(b) Remove the hole cover.

(c) Remove the nut and gasket.

(d) Disengage the clips to remove the front door outside moulding as shown in the illustration.

Remove in this Direction

    Disassembly
    DISASSEMBLY CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. REMOVE FRONT DOOR UPPER OUT ...

    Reassembly
    REASSEMBLY CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL OUTSIDE MOULDING RET ...

    Other materials:

    Toyota CH-R Service Manual > Safety Connect System: Ignition Switch Signal Malfunction (B15C6)
    DESCRIPTION If vehicle movement (10 km/h (6 mph) or more for 10 seconds) is detected based on the location data sent from the radio receiver assembly even when the telematics transceiver detects that the ignition switch is off, this DTC will be stored. DTC No. Detection I ...

    Toyota CH-R Service Manual > Side Airbag Sensor(for Front Door): Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the door side airbag sensor removal/installation are shown below. Necessary Procedure After Parts R ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0085