REASSEMBLY
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. INSTALL OUTSIDE MOULDING RETAINER
(a) When using a new front door outside moulding:
(1) Clean the surface of the front door outside moulding.
(b) When reusing the front door outside moulding:
(1) Remove the double-sided tape from the front door outside moulding.
(2) Wipe off any tape adhesive residue with cleaner.
(c) Install a new outside moulding retainer.
(1) Remove the peeling paper from the face of the outside moulding retainer.
HINT:
After removing the peeling paper, keep the exposed adhesive free from foreign matter.
(2) Install the outside moulding retainer as shown in the illustration. |
|
2. INSTALL FRONT DOOR UPPER OUTSIDE MOULDING PAD
(a) When using a new front door outside moulding:
(1) Clean the surface of the front door outside moulding.
(b) When reusing the front door outside moulding:
(1) Remove the double-sided tape from the front door outside moulding.
(2) Wipe off any tape adhesive residue with cleaner.
(c) Install a new front door upper outside moulding pad.
(1) Remove the peeling paper from the face of the front door upper outside moulding pad.
HINT:
After removing the peeling paper, keep the exposed adhesive free from foreign matter.
(2) Install the front door upper outside moulding pad as shown in the illustration. |
|
Toyota CH-R Service Manual > Horn: Horn
Components
COMPONENTS
ILLUSTRATION
*1
LOW PITCHED HORN ASSEMBLY
*2
NO.1 RADIATOR GRILLE RETAINER
*3
NO.1 RADIATOR TO SUPPORT SEAL
-
-
N*m (kgf*cm, ft.*lbf): Specified torque ...
Toyota CH-R Service Manual > Vehicle Stability Control System: Open in Stop Light Switch Circuit (C1425)
DESCRIPTION
The skid control ECU (brake actuator assembly) receives stop light switch signals
and uses them to determine whether or not the brakes are applied.
The skid control ECU (brake actuator assembly) has a detection circuit that it
uses to detect an open in the stop light input line.
I ...