INSTALLATION
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. INSTALL FRONT DOOR OUTSIDE MOULDING
(a) Remove the peeling paper from the face of the outside moulding retainer.
HINT:
After removing the peeling paper, keep the exposed adhesive free from foreign matter.
(b) Engage the clips to install the front door outside moulding as shown in the illustration.
|
Remove in this Direction |
(c) Remove the protective tape.
(d) Install the gasket and nut.
(e) Install the hole cover.
ReassemblyToyota CH-R Service Manual > Airbag System: Short in Rear Side Squib LH Circuit (B1855/63-B1858/63)
DESCRIPTION
The rear side squib LH circuit consists of the airbag sensor assembly and rear
seat airbag LH.
The airbag sensor assembly uses this circuit to deploy the airbag when deployment
conditions are met.
These DTCs are stored when a malfunction is detected in the rear side squib LH
cir ...
Toyota CH-R Owners Manual > Side doors: Unlocking and locking the doors from the inside
Door lock switches
Locks all the doors
Unlocks all the doors
Inside lock buttons
Locks the door
Unlocks the door
The front doors can be opened by pulling the inside handle even if the lock buttons
are in the lock position.
Locking the doors from the outside without a key ...