Toyota CH-R Service Manual: Inspection

Toyota CH-R Service Manual / Seat Belt / Rear Seat Outer Belt Assembly / Inspection

INSPECTION

PROCEDURE

1. INSPECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY

(a) Before installing the rear seat 3 point type outer belt assembly, check the ELR function.

NOTICE:

Do not disassemble the retractor.

(1) When the inclination of the retractor is 15° or less, check that the belt can be pulled from the retractor. When the inclination of the retractor is over 45°, check that the belt locks.

If the result is not as specified, replace the rear seat 3 point type outer belt assembly.

*a

Retractor

*b

Unlock

*c

Lock

*d

45°
    Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during ...

    Installation
    INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The procedure listed below is for the LH side. PROCEDURE 1. INSPECT REAR SEAT 3 PO ...

    Other materials:

    Toyota CH-R Owners Manual > Using the driving support systems: Driving assist systems
    To keep driving safety and performance, the following systems operate automatically in response to various driving situations. Be aware, however, that these systems are supplementary and should not be relied upon too heavily when operating the vehicle. ABS (Anti-lock Brake System) Helps to ...

    Toyota CH-R Service Manual > Seat Belt Warning System(w/ Occupant Classification System): Precaution
    PRECAUTION IGNITION SWITCH EXPRESSIONS HINT: The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section. Expression Ignition Switch (Position) Engine ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0135