Toyota CH-R Service Manual: Removal

Toyota CH-R Service Manual / Maintenance / Rear Disc Brake Pad(for Tmc Made) / Removal

REMOVAL

CAUTION / NOTICE / HINT

HINT:

  • The following procedure is for the LH side.
  • Use the same procedure for the RH side and LH side.

PROCEDURE

1. PRECAUTION

Click here

2. REMOVE REAR WHEEL

Click here

3. PERFORM REAR BRAKE PAD REPLACEMENT MODE

Click here

4. DRAIN BRAKE FLUID

NOTICE:

If brake fluid leaks onto any painted surface, immediately wash it off.

5. REMOVE REAR DISC BRAKE PAD

CAUTION:

  • After lifting up the rear disc brake cylinder assembly, secure it in place before performing any work on it.
  • The rear disc brake cylinder assembly could fall, pinching hands or fingers and causing injury.

(a) Disconnect the No. 2 parking brake wire assembly connector from the parking brake actuator assembly.

(b) Hold the rear disc brake cylinder slide pin, and remove the bolt.

*a

Hold

*b

Turn

(c) Pull the rear disc brake cylinder assembly upward.

(d) Remove the 2 rear disc brake pads from the rear disc brake cylinder mounting.

6. REMOVE REAR DISC BRAKE ANTI-SQUEAL SHIM KIT

(a) Remove the rear No. 1 disc brake anti-squeal shim and rear No. 2 disc brake anti-squeal shim from each rear disc brake pad.

(b) Using a screwdriver, remove the rear disc brake pad wear indicator plate from each rear disc brake pad.
    Components
    COMPONENTS ILLUSTRATION *1 REAR DISC BRAKE CYLINDER ASSEMBLY *2 REAR NO. 2 DISC BRAKE ANTI-SQUEAL SHIM *3 REAR NO. 1 DISC BR ...

    Installation
    INSTALLATION CAUTION / NOTICE / HINT NOTICE: After replacing the rear disc brake pads, the brake pedal may feel soft due to clearance between the rear disc brake pads and rear disc. Depress the b ...

    Other materials:

    Toyota CH-R Service Manual > Safety Connect System: Telematics Transceiver Malfunction (B15A8)
    DESCRIPTION This DTC is set when an error in the EEPROM or PLL IC is detected on the DCM (Telematics Transceiver) self-check. The EEPROM (Electrically Erasable Programmable Read-Only Memory) stores the various data to operate the safety connect system. The PLL IC (Phase-Locked Loop Integrated ...

    Toyota CH-R Service Manual > Automatic Light Control Sensor: On-vehicle Inspection
    ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT AUTOMATIC LIGHT CONTROL SENSOR (a) Check the wire harness. (1) Disconnect the automatic light control sensor (G1). (2) Measure the voltage according to the value(s) in the table below. Standard Voltage: Tester Connect ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0086