Toyota CH-R Service Manual: Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the transponder key ECU assembly removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced|
Replacement Part or Procedure |
Necessary Procedures |
Effects / Inoperative when not performed |
Link |
|---|---|---|---|
|
Disconnect cable from negative battery terminal |
Initialize back door lock |
Power door lock control system |
|
|
Memorize steering angle neutral point |
Lane departure alert system (w/ Steering Control) |
|
|
|
Pre-collision system |
|||
|
Transponder key ECU assembly |
Perform code registration (Immobiliser system) |
Engine starting |
w/o Smart Key System: |
PROCEDURE
1. REMOVE AIR CONDITIONER UNIT ASSEMBLY (for Cold Area Specification Vehicles)
Click here .gif)
2. REMOVE AIR CONDITIONER UNIT ASSEMBLY (except Cold Area Specification Vehicles)
Click here
3. REMOVE TRANSPONDER KEY ECU ASSEMBLY
(a) Disengage the guides to remove the transponder key ECU assembly as shown in the illustration.
.png)
.png) |
Remove in this Direction (1) |
.png) |
Remove in this Direction (2) |