CHECK MODE PROCEDURE
CHECK MODE (SIGNAL CHECK): DTC CHECK
(a) Turn the ignition switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the ignition switch ON.
(d) Turn the Techstream on.
(e) Enter the following menus: Body Electrical / SRS Airbag / Utility / Signal Check.
Body Electrical > SRS Airbag > Utility
Tester Display |
---|
Signal Check |
NOTICE:
Select Signal Check on the Techstream to clear the DTCs (both current and history).
HINT:
Toyota CH-R Service Manual > Combination Meter: Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration)
that must be performed after parts are removed, installed, or replaced during the
combination meter removal/installation are shown below.
Necessary Procedure After Parts Removed ...
Toyota CH-R Service Manual > Can Communication System: Dtc Combination Table
DTC COMBINATION TABLE
HOW TO INTERPRET COMMUNICATION DTCS (DTCS THAT START WITH U)
(a) If a CAN communication error cannot be reproduced, determine the suspected
malfunctioning part using the DTCs stored in ECUs that are connected to the CAN
buses by following the procedure below.
HINT:
Comm ...