Toyota CH-R Service Manual: Data List / Active Test

DATA LIST / ACTIVE TEST

HINT:

Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

DATA LIST FOR AIRBAG SENSOR ASSEMBLY

(a) Turn the ignition switch off.

(b) Connect the Techstream to the DLC3.

(c) Turn the ignition switch ON.

(d) Turn the Techstream on.

(e) Enter the following menus: Body Electrical / SRS Airbag / Data List.

(f) Read the Data List according to the display on the Techstream.

Body Electrical > SRS Airbag > Data List

Tester Display

Measurement Item

Range

Normal Condition

Diagnostic Note

Driver Seat Position

Driver Seat Position

Forward: Seat position is forward

Bkward: Seat position is backward

Fail: Failure is detected

Forward/Bkward

-

Display Type Information

Display Type Information

LR: Display is indicated by LH/RH

DP: Display is indicated by Driver/Passenger

LR

-

Number of Past DTC

Number of Past DTC

Min.: 0, Max.: 255

0

-

    Check Mode Procedure
    CHECK MODE PROCEDURE CHECK MODE (SIGNAL CHECK): DTC CHECK (a) Turn the ignition switch off. (b) Connect the Techstream to the DLC3. (c) Turn the ignition switch ON. (d) Turn the Techstream on. ( ...

    Diagnostic Trouble Code Chart
    DIAGNOSTIC TROUBLE CODE CHART Airbag System DTC No. Detection Item Link B1000/31 Center Airbag Sensor Assembly Malfunction ...

    Other materials:

    Toyota CH-R Service Manual > Meter / Gauge System: Engine Oil Pressure Switch Circuit
    DESCRIPTION The combination meter assembly and engine oil pressure switch assembly are connected via direct line. The combination meter assembly determines the engine oil pressure based on the engine oil pressure switch ON/OFF signal. HINT: The combination meter assembly receives vari ...

    Toyota CH-R Service Manual > Smart Key System(for Start Function): Power Source Mode does not Change to ON (IG)
    DESCRIPTION If the engine switch is pressed with the electrical key transmitter sub-assembly in the cabin, the certification ECU (smart key ECU assembly) receives a signal and changes the power source mode. Related Data List and Active Test Items Problem Symptom Data Lis ...

    Toyota C-HR (AX20) 2023-2025 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2025 Copyright www.tochr.net
    0.0103