Toyota CH-R Service Manual: Airbag Cut-off Switch

Toyota CH-R Service Manual / Supplemental Restraint Systems / Airbag Cut-off Switch

Components

COMPONENTS

ILLUSTRATION

*1

AIRBAG CUT OFF SWITCH CYLINDER SUB-ASSEMBLY

*2

INSTRUMENT PANEL FINISH END PANEL RH

Removal

REMOVAL

PROCEDURE

1. REMOVE INSTRUMENT PANEL FINISH END PANEL RH

Click here

2. REMOVE AIRBAG CUT OFF SWITCH CYLINDER SUB-ASSEMBLY

(a) Disengage the claws to remove the airbag cut off switch cylinder sub-assembly.

Inspection

INSPECTION

PROCEDURE

1. INSPECT AIRBAG CUT OFF SWITCH CYLINDER SUB-ASSEMBLY

(a) Check the resistance.

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

2 (PMC+) - 1 (PMC-)

Cut off switch in ON position

360 to 440 Ω

2 (PMC+) - 1 (PMC-)

Cut off switch in OFF position

90 to 110 Ω

If the result is not as specified, replace the airbag cut off switch cylinder sub-assembly.

*a

Component without harness connected

(Airbag Cut Off Switch Cylinder Sub-assembly)

Installation

INSTALLATION

PROCEDURE

1. INSTALL AIRBAG CUT OFF SWITCH CYLINDER SUB-ASSEMBLY

(a) Engage the claws to install the airbag cut off switch cylinder sub-assembly.

2. INSTALL INSTRUMENT PANEL FINISH END PANEL RH

Click here

    Airbag Cut-off Indicator Light
    Components COMPONENTS ILLUSTRATION *1 CLOCK ASSEMBLY *2 INSTRUMENT CLUSTER FINISH CENTER PANEL SUB-ASSEMBLY Inspection INSPECTION PROCE ...

    Airbag System
    ...

    Other materials:

    Toyota CH-R Service Manual > Power Steering System: EPS Warning Light Circuit
    DESCRIPTION If the power steering ECU assembly detects a malfunction, the power steering ECU assembly stores a DTC and illuminates the EPS warning light. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: If the power steering ECU assembly has been replaced, perform assist map writi ...

    Toyota CH-R Service Manual > Occupant Detection Sensor: Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the occupant detection sensor removal/installation are shown below. Necessary Procedure After Pa ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0072